Kotobukiya · Plastic Model

HAND UNIT WILD HAND2

$8,99 harga rilis≈ Rp 163.158Estimasi dari kurs harian USD→IDR · diperbarui 27 Okt 2026Belum termasuk biaya transaksi, pajak impor, atau ongkir.Sumber kurs

The popular Wild Hand is getting a continuation! This set is a new edition of the HAND UNIT MB40 WILD HAND known for its signature tough and powerful design. Four different sets of left and right hands are included, with swing joints attached on each hand. Users can enjoy combining this new unit with the first series. 3 types of connector parts are included. ・3.0mm Joints ・3.5mm Ball Joints ・5.0mm Ball Joint Attachments (can be attached to the 3.0mm joints.) The variety of connector parts allows these hand parts to be used with a variety of Kotobukiya’s plastic model units, including the Frame Arms and Hexa Gear lines. Set Lineup: [Weapon Holding Hands 2] The hands hold weapons at a shallow angle. These are perfect for blade weapons, such as swords and spears, and can accommodate poses with the weapon facing forwards. Swapping out the swing joint also allows for two different angles of movement. [Open Hands 2] These are new hands with the fingers spread wide open. While the hands can be used as is, the swing joint allows for more dynamic posing, such as slapping and landing. [Open Hands 3 (Spear Hands)] New to the Wild Hand units, this open hand shares a design with that in HAND UNIT MB41 SHARP HAND. Utilizing the swing joint, the open hands with aligned fingertips can be used for not only hand-to-hand combat and salutes but also a range of other poses, including karate palm strikes. [Thumbs-Up Hands] A new powerful-looking hand with its thumb sticking straight up. The hand can be posed both directed at someone or directed at the figure, for a confident, powerful look. Expression Parts (1 Set of Left and Right Pieces for Each): ・Weapon Holding Hands 2 ・Open Hands 2 ・Open Hands 3 (Spear Hands) ・Thumbs Up Hands Connector Parts (8 Each + 1 Set of Angled Parts for Left/Right) ・3.0mm Joints ・3.5mm Ball Joints ・5.0mm Ball Joint Attachments (can be attached to the 3.0mm joints.) *Prototype shown, final product may vary. *This product requires assembly.